Foot and Heel Pain – Low Dye Tape Support

So anchor strips. So you want to make sure that you're not at the metatarsal. Okay, so stay off of the MTP area on that part. 

Below the head you mean? 

Yeah below the head of the metatarsal. And you're going to apply with no tension, and you can leave a gap there. So you didn't do a couple strips, but because Lisa's got a bit of a smaller foot, like with yours, maybe I'll do like two strips right. And so for you, remember, you want to make sure you over lap by half, right? 


Okay. So I normally like to go a little bit thinner than this. I usually do like thirds. So I'm going to get you to turn over on your tummy, with your leg hanging off. Okay. So...

I know it's hard, but just be careful with that.

Okay. So...

Do you wanna switch spots.

Alright. So if they're getting pain in through here, you want to support that. So there's a few different ways of doing it. You can vary it up depending on how they feel. Make sure you start off with anchor strip here in the inside. So you want to eventually overlap by half as well. So if you're using the small strips, then you've got to be careful with that.

So you want to start off sort of more right on the medial aspect. And make sure that you don't put too much pressure in through here. You're not cranking. So that's important, because otherwise it's going to get really uncomfortable for her right. And don't go too high. If you go too high, then it all starts to rub under this area, which will be uncomfortable.

So you want to stay right on the calcaneus here. And so you want to also go right to the lateral side as well. So you can do that or you can come in, depending on if she's getting a little bit more sort of pain down through here, to support that a little more. You can do a little teardrop. So really important that this, so what I just did there, you don't want to do, because I'm also talking through this, right, you want to be able to not let it wrinkle. Okay, so that's the first strip. I always go medial lateral, medial lateral, medial lateral. Okay. Sometimes three strips on each side may add too much discomfort onto here. So sometimes I'll go maybe three and two or just two and two.

What if you just do an X?

You can do that too. Yep.

Just go from that side to that side. Just one variation is what you're showing.

Yeah. So you can even just go straight across, so you can just do like a U. Or so with the X, see how it causes the X so you can do that's where I'm supporting in through here a little bit more.

Why would you choose one over the other?

Just depending on what's going on from the ... oh yeah I can get a lot of pain in through there. Then you can support that, that area a little more there, or if it's more immediately then I'll and go that way a little more. Okay. So if that's what I choose and I'm just going to keep repeating that. And so the reason why I started more immediately is because I'm going to go more towards the plantar area. So here I'm going by a half, and then I'm actually overlapping the whole thing and then coming overlapping by half again. Okay. Like that. Sorry that's a  U strip. So this is where it gets a little tricky.. 

When is just the U strip beneficial?

It will support the bottom part more. So if you get a lot of like, tightness in through here, it'll support this area more, right.

More that the X?

Yeah. I mean, they're both really good. Sometimes this can really just give you a lot more support just in the whole heel too, right. And the strain off of here. So laterally. So I'd probably just go two strips with her and then, you know, if she's like, Oh yeah, you know, I do get a little more here, then I can do one strip or next strip, one cross strip, and then one U strip. Just be really careful, you don't hold again. And then, we need you to turn back on your back please.

Okay so because I also want to make sure you remember how I said it supinates a little bit, so I want to go this way. Just so that way, it just helps to bring it back into a little bit less supination, right. So that's the anchor strip. Now here I can also go, I'm just to cover that up, because remember we talked about last week, you want to avoid windows, right? So this has a little bit of a window there, that might be a little bit uncomfortable and sometimes we're like, Oh no, I don't want that up there because it'd be uncomfortable to your individual, right? 

So you can go all the way up, or then you're like, Oh yeah, that's, so you can leave it there and just close it there. That's okay because these windows aren't as bad. Okay. It's the windows that are up in through here because how she moves, that doesn't really move right. So that's not going to be a big issue. But I like to cover it up sometimes, but sometimes they'll be like, Oh, that's uncomfortable. I like to put an extra one on.

I’m going to get you to stand on the table with only like 10%, so stand on the table with most of the weight on that leg or on your knee is actually fine. And then you can just relax… So basically, what we’re going to do when I ask you, you're going to press down as hard as you can. Press down as hard as you can. Okay. And once she's got that a hundred percent weight bearing, then we close it off, right. So that way that gives it that breathability and that sort of flex. Ok a 100% and it closes the anchor strip. And a 100%, there you go.